F2102 It Was Impossible To Address I2C Memory - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Rexroth IndraDrive
F2102 It was impossible to address I2C memory
Cause
Failure occurs sporadically (firmware error)
Encoder cable defective or bad shielding
Encoder memory or encoder electronics is defective
Hardware defect on control section
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
When addressing a memory via the I
Remedy
Clear error and contact our service department in order
to get a firmware update
Clear error. Replace defective encoder cable or improve
shielding
Clear error. Replace encoder or motor
Replace control section or entire drive controller
Note:
Only Rexroth service engineers or especially trained users are
allowed to replace the control section. The replacement of the
entire drive controller is described in the Project Planning
Manual for the power section.
See also Functional Description "Measuring Systems"
F2102 - Attributes
Display:
F2102
Mess. no.:
F2102 (hex)
Error Messages
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
2
C bus an error occurred.
7-111
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
