F2006 Mmc Was Removed - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
7-76
Error Messages
F2006 MMC was removed
Cause
The MMC is used as active memory and was
removed from the drive controller under voltage
Loose contact in MMC slot or MMC incorrectly
plugged
MMC defective
MMC slot defective
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
The drive monitors whether the MMC is available when it is used as an
active memory, i.e. when the parameters are stored in the MMC.
Remedy
Put MMC in its slot at the drive controller again and then
start command S-0-0099, C0500 Reset class 1
diagnostics in order to clear error
Check fixing of MMC and, if necessary, plug it in
correctly
Replace MMC
Replace control section or entire drive controller
Note:
Only Rexroth service engineers or especially trained users are
allowed to replace the control section. The replacement of the
entire drive controller is described in the Project Planning
Manual for the power section.
F2006 - Attributes
Display:
F2006
Mess. no.:
F2006 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
