F4005 Error During Phase Regression; F4006 Phase Switching Without Ready Signal - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Rexroth IndraDrive
F4005 Error during phase regression
Cause
Error in SERCOS master module of control unit
F4006 Phase switching without ready signal
Cause
Error in SERCOS master module of control unit
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
When regressing from a communication phase the drive wasn't switched
to communication phase 0.
Remedy
Error can only be corrected after consultation with
control unit manufacturer
See also Functional Description "Interface Errors and Diagnostic
Possibilities"
F4005 - Attributes
Display:
F4005
Mess. no.:
F4005 (hex)
Supported by Firmware Variant:
The SERCOS master tried to carry out a phase switch without waiting for
the ready signal from the drive.
Remedy
Error can only be corrected after consultation with
control unit manufacturer
See also Functional Description "Interface Errors and Diagnostic
Possibilities"
F4006 - Attributes
Display:
F4006
Mess. no.:
F4006 (hex)
Error Messages
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
7-53
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
