C3901 Abrasion Of Brake Only Possible With Drive Enable; C3902 Error During Abrasion Of Brake - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
9-120
Command Diagnostic Messages
C3901 Abrasion of brake only possible with drive enable
Cause
Command was activated without drive enable ("AF")
having been set
C3902 Error during abrasion of brake
Cause
Torque of the amplifier is reduced
Axis is mechanically blocked
Axis is at end stop or runs towards it
Abrasion of brake is impossible because motor
generates less torque than holding torque of brake
Sum of weight load and brake torque is greater than
motor peak torque
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
It is impossible to execute the command P-0-0544, C3900 Command
Abrasion of brake.
Remedy
Switch drive to "AF", then start command P-0-0544,
C3900 Command Abrasion of brake
See also Functional Description "Motor Holding Brake"
C3901 - Attributes
Display:
C3901
Mess. no.:
C3901 (hex)
Supported by Firmware Variant:
The execution of the command "abrasion of brake" (P-0-0544, C3900
Command Abrasion of brake) was aborted by an error.
Remedy
Remove reduction
Remove mechanical blocking
Choose axis position such that sufficient motion is
possible
Check whether there are torque limitations active in
drive or whether controller was sufficiently dimensioned
Reduce weight load, if possible
See also Functional Description "Motor Holding Brake"
C3902 - Attributes
Display:
C3902
Mess. no.:
C3902 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
