9-108
Command Diagnostic Messages
C2903 Error when accessing the MMC
Cause
A transmission error occurred during transmission
of firmware from MMC
Firmware file (ibf file) available on MMC is not
correct (does not match control section)
Supported by Firmware Variant:
During the execution of P-0-4072, C2900 Command Firmware update
from MMC a check is run to find out whether the firmware was correctly
loaded.
Remedy
Execute P-0-4072, C2900 Command Firmware update
from MMC again.
If error occurs again, contact a Rexroth service engineer
Use different MMC with firmware file appropriate for
control section
– control section CSH01.1C: firmware MPH
– control section CSB01.1x: firmware MPB
– control section CDB01.1x: firmware MPD
Note:
If the command error occurs during the transmission of the
firmware to an optional module, the respective system error
(F8xxx) is displayed in addition to the command error C2903.
C2903 - Attributes
Display:
C2903
Mess. no.:
C2903 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
DOK-INDRV*-GEN-**VRS**-WA01-EN-P