C07_2 Load Def. Proc. Com. (Load Def. Pr. For Safety Techn.) - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Rexroth IndraDrive
C07_2 Load def. proc. com. (load def. pr. for safety techn.)
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
The C07_2 message on the display of the drive controller shows that the
C07_2 Load def. proc. com. (load def. pr. for safety techn.) command
was activated.
The command can be started as follows:
1. Enter value 165 for "load defaults procedure for safety technology" in
parameter P-0-4090, Index for C07 Load defaults procedure
2. Start S-0-0262, C07_x Load defaults procedure command
Note:
It is possible to start further commands with parameter
S-0-0262. In parameter P-0-4090, Index for C07 Load
defaults procedure it is possible to set which commands is
started.
The command C07_2 Load def. proc. com. (load def. pr. for safety
techn.) deactivates the safety technology and sets all safety technology
parameters to their default value.
The command C07_2 Load def. proc. com. (load
def. pr. for safety techn.) overwrites user-
defined safety technology settings!
⇒ Only use this command if you want to commission
CAUTION
safety technology again.
C0720 - Attributes
Display:
C07_2
Mess. no.:
C0720 (hex)
Command Diagnostic Messages
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
9-5
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
