9-80
Command Diagnostic Messages
C0799 An invalid index was set
C0851 Parameter default value incorrect (-> S-0-0021)
Supported by Firmware Variant:
At the time the command S-0-0262, C07_x Load defaults procedure
command was started no valid value had been entered in P-0-4090,
Index for C07 Load defaults procedure.
Note:
The function of the command S-0-0262, C07_x Load defaults
procedure command can be set via P-0-4090, Index for C07
Load defaults procedure.
After the command was cleared the value in P-0-4090, Index
for C07 Load defaults procedure is automatically set to "0"
again.
C0799 - Attributes
Display:
C0799
Mess. no.:
C0799 (hex)
Supported by Supply Unit:
Note:
This command error can only occur as a result of the C0800
Load basic parameters command that can only be used by
the manufacturer!
C0851 - Attributes
Display:
C0851
Mess. no.:
C0851 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
HMV01
DOK-INDRV*-GEN-**VRS**-WA01-EN-P