Error Messages; Fatal System Errors (F9Xxx And E-Xxxx); Behavior In The Case Of Fatal System Error - Bosch Rexroth IndraDrive Troubleshooting Manual

Hide thumbs Also See for Rexroth IndraDrive:
Table of Contents
Rexroth IndraDrive

Error Messages


Fatal System Errors (F9xxx and E-xxxx)

Behavior in the Case of Fatal System Error

Drive Behavior
Steps of Commissioning
LSA Control S.L. [email protected] (+34) 960 62 43 01
In the case of fatal system errors there is a grave problem in the drive
system (e.g. watchdog error, processor crash, ...) which does no longer
allow regular operation of the drive. Due to a hardware or firmware error,
the drive firmware is no longer operable; clearing an error is no longer
In this case the drive reacts automatically as follows:
• All digital outputs are set to "0".
Safety technology: safety related feedback is deactivated!
• The "ready for operation" relay opens, this also switches power off in
case the wiring is correct.
• The output stage is locked, this disables the drive torque.
• The brake output is deactivated; if a self-holding brake is used, it is
• One of the following diagnostic messages is output at the display:
• F9xxx (fatal system errors),
• E8xxx (exceptions),
• or E-0800 (watchdog)
• An English diagnostic message text is output via the serial interface.
After a fatal system error has occurred, the drive can only be
commissioned again when:
1. the 24 V supply is completely switched off and on so that a restart of
the drive is carried out (incl. booting process and initialization).
2. the drive is run up to the operating mode again.
3. power is switched on again (as the "ready for operation" relay has
opened before and power was switched off in case the wiring is
In case fatal system errors are occurring repeatedly, contact
our service department as operating the drive then is no
longer possible.
Error Messages

Hide quick links:

Table of Contents

Table of Contents