Index - Bosch Rexroth IndraDrive Troubleshooting Manual

Hide thumbs Also See for Rexroth IndraDrive:
Table of Contents
Rexroth IndraDrive
13

Index

DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
+
+24Volt DC error 7-16
A
Ab 5-1
Abrasion of brake only possible with drive enable 9-120
Absolute encoder offset cannot be saved 9-69
Absolute evaluation of measuring system impossible 9-68
AC 5-1
Acceleration threshold exceeded 7-33
Acquisition velocity not allowed 9-116
Act. modulo value cycle greater than max. travel range 9-59, 9-111
Activation time of enabling control exceeded 7-68
Actual pos. value 1 outside absolute encoder window 7-104
Actual pos. value 2 outside absolute encoder window 7-105
Actual pos. value 3 outside absolute encoder window 7-106
AE 5-1
AF 5-1
AH 5-1
An invalid index was set 9-80
Analog input adjust command 9-12
Appropriate use
Introduction 2-1
Appropriate uses
Uses 2-2
AS 5-1
ASP 5-1
AU 5-1
Autom. commutation
max. motion range 7-8
max. motion range when moving back 7-6
Automatic adjust failed 9-107
Automatic baud rate detection for SERCOS interface 6-5
Automatic commutation
current too low 7-9, 9-88
iteration without result 7-12, 9-90
overcurrent 7-10, 9-89
timeout 7-11, 9-89
Automatic controller setting failed 9-95
Automatic drive check and adjustment 6-37
B
Backup working memory procedure command 9-10
bb 5-1
BOOT 1.1 4-1
Both travel range limit switches activated 7-46, 8-7
Brake check command 9-10
Brake check function not possible 9-59
Brake check only possible with drive enable 9-98
Brake torque too low 8-35, 9-99
Braking resistor overload 7-123
Braking resistor overload prewarning 8-45
Bus failure 7-54
C
Cable
replacing 10-13
Cam shaft invalid 7-75
Cam shaft, encoder 1, real master axis 6-23
Cam shaft, encoder 1, virtual master axis 6-22
Cam shaft, encoder 2, real master axis 6-23
13-1
Index

Hide quick links:

Table of Contents
loading

Table of Contents