F8014 Automatic Commutation: Overcurrent - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
7-10
Error Messages
F8014 Automatic commutation: overcurrent
Cause
Amplitude of actual current value is higher than
allowed maximum current
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
The actual current value amplitude resulting from automatic commutation
offset determination is monitored. When a maximum value is exceeded,
the error F8014 is generated.
Remedy
Reduce signal voltage (P-0-0506, Voltage amplitude
for angle acquisition) or increase signal frequency
(P-0-0507, Test frequency for angle acquisition)
- or -
With P-0-0506, Voltage amplitude for angle
acquisition=0 start automatic determination of
appropriate values
Note:
If error occurs repeatedly, please contact our service
department.
F8014 - Attributes
Display:
F8014
Mess. no.:
F8014 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
