C07_0 Load Defaults Procedure Com. (Load Controller Param.) - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
9-4
Command Diagnostic Messages
C07_0 Load defaults procedure com. (load controller param.)
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
The C07_0 message on the display of the drive controller shows that the
C07_0
Load
defaults
parameters) command was activated.
The command can be started as follows:
• by means of the S-0-0262, C07_x Load defaults procedure
command parameter or
• by means of the control panel of the drive controller or
• by starting the S-0-0099, C0500 Reset class 1 diagnostics command
if the drive controller displays "RL" (occurs if the S-0-0141, Motor type
and P-0-2141, Motor type, encoder memory parameters are
different).
Note:
With parameter S-0-0262 it is possible to start another
command, the C07_1 Load defaults procedure command
(load base parameters) command. In parameter P-0-4090,
Index for C07 Load defaults procedure it is possible to set
which of both commands is started.
The C07_0 Load defaults procedure command (load controller
parameters) can only be carried out in the case of motors of the MHD,
MKD and MKE series. In the case of these motors, the controller
parameters are loaded from the motor encoder data memory to the drive
controller and some controller parameters are set to their default values.
With the C07_0 Load defaults procedure
command (load controller parameters)
command user-defined controller settings are
overwritten!
CAUTION
⇒ Only use this command if you want to load standard
controller parameter values. For saving and then
loading user-defined parameter values specific
commands are available.
See
also
Functional
Parameters"
See also Functional Description "Control Panel of the IndraDrive
Controllers"
C0700 - Attributes
Display:
C07_0
Mess. no.:
C0700 (hex)
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
procedure
command
Description
"Loading,
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
Rexroth IndraDrive
(load
controller
Storing
and
Saving
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
