C0225 Initialization Velocity Encoder 2 Too High - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Rexroth IndraDrive
C0225 Initialization velocity encoder 2 too high
Cause
Velocity for initialization of encoder 2 was too high
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
During the execution of the command S-0-0128, C0200 Communication
phase 4 transition check an error in the initialization velocity of
encoder 2 (optional encoder) was detected.
Remedy
Reduce velocity for encoder initialization
For removing command errors see "Command Errors"
C0225 - Attributes
Display:
C0225
Mess. no.:
C0225 (hex)
Command Diagnostic Messages
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
9-55
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
