C0852 Locked With Password; C0902 Spindle Positioning Requires Drive Enable - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Rexroth IndraDrive
C0852 Locked with password
C0902 Spindle positioning requires drive enable
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Supply Unit:
Note:
This command error can only occur as a result of the C0800
Load basic parameters command that can only be used by
the manufacturer!
C0852 - Attributes
Display:
C0852
Mess. no.:
C0852 (hex)
Supported by Firmware Variant:
During the execution of the command for spindle positioning (C0900) an
error was detected.
Cause:
At the start of the S-0-0152, C0900 Position spindle command the drive
was not yet in drive enable.
Remedy:
Set drive enable before starting the command.
C0902 - Attributes
Display:
C0902
Mess. no.:
C0902 (hex)
Command Diagnostic Messages
HMV01
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
9-81
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
