C07_1 Load Defaults Procedure Com. (Load Basic Parameters); C0800 Load Basic Parameters Command; C0900 Position Spindle Command - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
9-6
Command Diagnostic Messages
C07_1 Load defaults procedure com. (load basic parameters)
C0800 Load basic parameters command
C0900 Position spindle command
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
The basic parameter set (firmware-specific default values for all
parameters) stored in the firmware is loaded. All previous parameters are
overwritten.
C0750 - Attributes
Display:
C07_1
Mess. no.:
C0750 (hex)
Supported by Supply Unit:
Note:
This command is only available for manufacturer-side testing
and developing purposes!
C0800 - Attributes
Display:
C08
Mess. no.:
C0800 (hex)
Supported by Firmware Variant:
Via the control unit the S-0-0152, C0900 Position spindle command
parameter was activated.
See also Functional Description "Spindle Positioning"
C0900 - Attributes
Display:
C09
Mess. no.:
C0900 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
HMV01
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
