C0300 Command Set Absolute Measuring; C0400 Switching To Parameter Mode - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
9-2
Command Diagnostic Messages
C0300 Command Set absolute measuring
C0400 Switching to parameter mode
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
Supported by Firmware Variant:
The command for setting the absolute measuring P-0-0012, C0300
Command Set absolute measuring was activated.
See also Functional Description "Set Absolute Measuring"
C0300 - Attributes
Display:
C03
Mess. no.:
C0300 (hex)
Supported by Firmware Variant:
Supported by Supply Unit:
The command for switching to the parameter mode was started by means
of the P-0-4023, C0400 Communication phase 2 transition parameter.
Note:
This command has to be carried out before editing parameters
that can only be written in the parameter mode.
C0400 - Attributes
Display:
C04
Mess. no.:
C0400 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
HMV01
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
