Bosch Rexroth IndraDrive Troubleshooting Manual page 422
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Rexroth IndraDrive
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
G
generation of diagnostic messages, drive-internal 1-1
H
Hardware trap 7-4
HMV
Braking resistor overload 7-123
HMV
+/-15Volt DC error 7-16
+24Volt DC error 7-16
Braking resistor overload prewarning 8-45
Communication phase 0 6-1
Communication phase 1 6-2
Communication phase 2 6-3
Communication phase 3 6-4
Communication phase 3 transition check 9-1
Communication phase 4 transition check 9-1
Connection error mains choke 7-27
Contactor control error 7-126
Control and power sections ready for operation 6-6
Current measurement trim wrong 7-107
DC bus charging active 6-35
DC bus quick discharge active 6-36
DC bus timeout 8-39
Device overload prewarning 8-33
Device overload shutdown 7-15
Device overload, current limit active 8-11
Device overtemp. Prewarning 8-25
Device overtemperature shutdown 7-83
Device temperature monitor defective 7-85
Drive active, switching not allowed 9-69
Drive system not ready for operation 8-41
Error balancing monitor/ground fault 7-126
Error in control of braking resistor 7-124
Error in non-cyclical data communic. of power section 7-114
Error internal function call 7-3
Error supply shutdown 7-127
Ground fault in motor line 7-125
Hardware trap 7-4
Hardware variant not supported 7-128
Incorrect interrupt timing 7-128
Invalid control section data (->S-0-0022) 9-51
Invalid device code 7-127
Invalid parameters (-> S-0-0021) 9-17
Invalid parameters (->S-0-0022) 9-49
Limit error in parameter (-> S-0-0021) 9-18
Load basic parameters command 9-6
Locked with password 9-81
Mains failure 7-122, 8-44
Module group communication error 7-109
Overcurrent in mains-side power section 7-127
Overvoltage in mains 7-120, 8-43
Overvoltage in power section 7-121, 8-1
Parameter calculation error (->S-0-0022) 9-50
Parameter default value incorrect (-> S-0-0021) 9-80
Parameter limit error (->S-0-0022) 9-50
Phase failure 7-122, 8-44
PL Load parameter default values 7-79
PLL is not synchronized 7-119
Ready for power on 6-7
Reset class 1 diagnostics, error reset 9-3
Softstart fault power supply unit 7-121
Supply module in current control 6-34
Supply module in operation 6-34
Supply module in voltage control 6-34
Switching to parameter mode 9-2
Test run active 6-36
Test run for current control 6-35
Test run for voltage control 6-35
13-5
Index
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Table of Contents
