Table of Contents
MAINTENANCE
WHEEL TOE ALIGNMENT INSPECTION
1. Place machine on a smooth level surface and set
steering wheel in a straight ahead position. Secure
the steering wheel in this position.
2. Place a chalk mark on the center line of the front tires
approximately 10" (25.4 cm) from the floor or as close
to the hub/axle center line as possible
NOTICE
It is important the height of both marks be equally
positioned to get an accurate measurement.
3. Measure the distance between the marks and record
the measurement. Call this measurement
2.50
4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the
hub/axle center line.
q
.
5. Measure the distance between the marks and record.
Call this measurement
from measurement
means the measurement at the front of the tire
wider than the measurement at the rear
just the opposite.
w
.
1/4" (0.64 mm) toe-in – 1/4" (0.64 mm) toe-out
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
e
. Subtract measurement
w
, this is the vehicle toe. Toe-out
MEASUREMENT
Wheel Toe:
© Copyright Polaris Industries Inc.
e
w
is
e
. Toe-in is
Chapters
Table of Contents
Troubleshooting
