Table of Contents
DRIVE SHAFT
FRONT DRIVE SHAFT REMOVAL
1. Elevate front of vehicle and safely support machine
under the frame area.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
2. Remove the four wheels nuts and remove the front
wheel.
q
3. Remove the cotter pin
w
hub castle nut
. Remove the nut, and cone washer
e
from the front wheel hub assembly.
4. Remove and discard the two front brake caliper
mounting bolts and remove the caliper from the brake
disc. Refer to Front Brake Caliper Removal page 9.13
in the Brake System chapter.
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.
5. Remove the front wheel hub assembly.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
and loosen the front wheel
6. Remove and discard the upper and lower ball joint
r
pinch bolts
and nuts.
7. Using a soft faced hammer, lightly tap on the bearing
carrier while removing the upper the joint end.
8. Remove the drive shaft from the front bearing carrier.
9. With a short, sharp jerk, remove drive shaft from the
front gearcase.
FINAL DRIVE
7
7.11
Chapters
Table of Contents
Troubleshooting
