Table of Contents
ENGINE / COOLING SYSTEM
CRANKSHAFT PTO SEAL INSTALLATION
w
1. Install new seal
into crankcase. Thread the drive
bolt of special tool PU-52493
IMPORTANT
The orientation of the seal is critical. Install the seal with
the flat side of the seal facing out as shown.
3.48
q
into the crankshaft.
2. Tighten the drive bolt
out against the crankcase.
3. Once the seal is properly installed, loosen the drive
e
bolt
and remove special tool PU-52493 from the
crankshaft.
4. Refer to Inner PVT Cover installation.
5. Field test the vehicle before putting back into service.
Inspect for any leaks.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
e
r
until the cylinder
bottoms
© Copyright Polaris Industries Inc.
Chapters
Table of Contents
Troubleshooting
