Table of Contents
REAR BEARING CARRIER INSTALLATION
1. Install drive shaft through the backside of the bearing
carrier.
2. Install the four fasteners
bearing carrier to the trailing arm. Install the one
w
fastener
that attaches the upper radius rod to the
bearing carrier. Torque bolts to specification.
NOTICE
Use new nuts upon installation of the rear bearing
carrier.
TORQUE
Bearing Carrier to Trailing Arm Bolts:
42 ft-lb (54 Nm)
Outer Radius Rod Fastener:
50 ft-lbs (68 Nm) + 90°
3. Apply anti-seize to drive shaft splines.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
4. Install rear wheel hub assembly
5. Install the rear brake caliper assembly and new bolts
q
that attach the rear
6. Install
and hand tighten the castle nut. Install washers with
domed side out.
r
. Torque to specification.
TORQUE
Rear Caliper Mounting Bolts:
46 ft-lbs (62 Nm)
lower
radius
rod.
specification.
TORQUE
Outer Radius Rod Fastener:
50 ft-lbs (68 Nm) + 90°
FINAL DRIVE
w
e
, cone washer
,
7
Torque
fastener
to
7.9
Chapters
Table of Contents
Troubleshooting
