Key Interlock Cable Removal And Installation - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (18 pages)
Table of Contents
2) Remove adjuster (cable end) from select lever pin of
select lever assembly.
3) Remove adjuster (cable end) from select lever pin of
select lever assembly.
4) Release lock plate (1) which restrict moving of cable
end holder (2).
5) Push cable end holder (1) out from eye-end (2) using
an appropriate tool (3) to disengage cable.
6) Shift select lever to "N" position.
7) Apply grease to select lever pin and install adjuster
(cable end) to it.
: Grease 99000–25011 (SUZUKI Super Grease
A)
8) With both select lever and transmission range
sensor kept each "N" position, drive cable end holder
(1) in until it locks cable.
9) Slide lock plate (2) to secure cable end holder in
position.
10) After select cable was installed, check for the
following.
• Push vehicle with select lever shifted to "P" range.
Vehicle should not move.
• Vehicle can not be driven in "N" range.
• Vehicle can be driven in "D", "3", "2" and "L"
ranges.
• Vehicle can be backed in "R" range.
Key Interlock Cable Removal and Installation
NOTE
Don't bend interlock cable excessively when
removing and installing it, or system will not
operate correctly.
Removal
1) If the vehicle is equipped with air bag system,
disconnect negative cable at battery and disable air
bag system, referring to "Disabling Air Bag System in
Section 8B".
I2RH01510046-01
2) Remove steering column cover.
3) Turn ignition switch to ACC position.
4) Pull out key interlock cable (1) from key cylinder
cover (2) while pressing checkhook with slotted
screwdriver (3) or the like.
I2RH01510047-01
5) Turn ignition switch to LOCK position.
6) Remove console box referring to "Console Box
Components in Section 9H".
7) Detach cable end (1) from interlock cam (2) while
pressing claws (3) of interlock cam boss.
At this time, be careful not to cause damage to its
claws.
Detach cable casing cap (4) from bracket (5) while
pressing checkhook.
8) Remove interlock cable.
I3RM0B510037-01
Automatic Transmission/Transaxle:
1
3
2
1
3
4
5A-89
S7RW0A5106014
2
I5RW0C510045-01
4
5
I5RW0C510046-01
Chapters
Table of Contents
Troubleshooting
