Suzuki SX4 Service Manual page 535
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (278 pages)
Table of Contents
26) Clean mating surface of differential carrier (1) and
differential cover, apply sealant to carrier as shown
in figure by such amount that its section is 1.5 mm
(0.059 in.) in diameter, mate differential cover with
differential carrier, and then tighten bolts to specified
torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Differential cover bolt: 23 N·m (2.3 kgf-m, 17.0
lb-ft)
27) Assemble coupling case as follows.
a) Install bearing using special tool and hydraulic
press.
Special tool
(A): 09913–75830
b) Install snap ring using snap ring pliers.
c) Apply grease to oil seal lip, install oil seal (2) to
coupling case (1) using special tool as shown in
figure.
NOTE
Install oil seal horizontally to surface of
coupling case.
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
Distance between case and oil seal "a"
: 1.5 – 2.5 mm (0.06 – 0.10 in.)
Special tool
(A): 09913–75810
"A"
1
I5RW0A320058-02
(A)
I5RW0A320059-02
(A)
28) Install spacer (1) to coupling assembly (2) as shown
in figure.
2
1
29) Install grommet of coupling harness into groove of
coupling case and then install coupling assembly by
using hydraulic press.
30) Install companion flange to pinion, and then hold
companion flange with special tool and tighten flange
nut.
Tightening torque
Flange nut: 110 N·m (11.0 kgf-m, 79.5 lb-ft)
Special tool
(A): 09930–40113
Differential:
3B-46
2, "A"
"a"
1
1
I5RW0A320060-02
2
1
I5RW0A320065-01
(A)
I5RW0A320061-01
Chapters
Table of Contents
Troubleshooting
