Hide thumbs Also See for SX4:
Table of Contents
3A-9 Drive Shaft / Axle: Front
17) Fit boot (1) to grooves of shaft and housing (2) and
adjust length to specification below.
Insert screw driver into boot and allow air to enter
boot so that air pressure in boot becomes the same
as atmospheric pressure.
Drive shaft boot fixing position (distance
between housing end and small boot band
center)
Left side drive shaft "a": 170 mm (6.69 in.)
Right side drive shaft "b": 189 mm (7.44 in.)
[A]: Left side drive shaft
[B]: Right side drive shaft
CAUTION
!
• Bend each boot band against forward
rotation.
• Do not squeeze or distort boot when
fastening it with bands. Distorted boot
caused by squeezing air may reduce its
durability.
18) Place differential side boot (or center shaft side) new
big band (3) and new small band (4) onto boot
putting band outer end (1) against forward rotation
(2) as shown in figure.
19) Fasten differential side (or center shaft side) boot
band.
• For differential side (or center shaft side) boot big
band
Fasten band (1) by drawing hooks (2) with special
tool and engage hooks (3) in slot and window (4).
Special tool
(A): 09943–57021
• For differential side (or center shaft side) boot
small band
Fasten band (5) using special tool as shown in
figure.
Distance "a"
: 2.6 ± 1.4 mm (0.102 ± 0.055 in.)
Special tool
(B): 09943–57010
I5RW0A311005-01
I5JB0A311006-01
(A)
1
2
5
(B)
4
3
"a"
I5RS0B310013-01
Table of Contents
loading

Table of Contents