Steering Angle Sensor Inspection (Esp® Model); Steering Column Removal And Installation - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (278 pages) ,
- Owner's manual (16 pages)
Table of Contents
6B-7 Steering Wheel and Column:
Installation
1) Install steering angle sensor (2) by fitting
engagement parts (1) of contact coil cable assembly
to claws of steering angle sensor as shown in figure.
1
2
2) Install contact coil cable assembly and steering
wheel. Refer to "Contact Coil Cable Assembly
Removal and Installation" and "Steering Wheel
Removal and Installation".
Steering Angle Sensor Inspection (ESP®
model)
Refer to "Steering Angle Sensor Inspection in Section
4F".
Steering Column Removal and Installation
CAUTION
!
Once the steering column is removed from
the vehicle, the column is extremely
susceptible to damage.
• Dropping the column assembly on its end
could collapse the steering shaft or loosen
the plastic shear pins which maintain
column length.
• Leaning on the column assembly could
cause it to bend or deform.
Any of the damage could impair the column's
collapsible design.
Steering column mounting nuts should not
be loosened with steering shaft joint upper
side bolt tightened as this could cause
damage to shaft joint bearing.
NOTE
When servicing steering column or any
column-mounted component, remove
steering wheel. But when removing steering
column simply to gain access to instrument
panel components, leave steering wheel
installed on steering column.
Removal
WARNING
!
Never rest a steering column assembly on
the steering wheel with the air bag (inflator)
module face down and column vertical.
Otherwise, personal injury may result.
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System in Section 8B".
3) Remove steering wheel and contact coil cable
1
assembly referring to "Steering Wheel Removal and
Installation" and "Contact Coil Cable Assembly
I6JB01620004-01
Removal and Installation".
4) (Immobilizer model)
Remove immobilizer control module from steering
column, referring to "ICM Removal and Installation in
Section 10C".
5) Detach lighting switch and wiper switch from steering
column.
6) Remove lower shaft upper joint bolt (1).
S7RW0A6206012
S7RW0A6206006
7) Remove steering column mounting nuts (1), and
then remove steering column from vehicle.
NOTE
Do not move tilt lever until mounting bolts
and nuts are tightened to specified torque.
1
1
I5RW0A620005-01
1
I4RS0A620017-01
Chapters
Table of Contents
Troubleshooting
