Drive Shaft / Axle; Front; General Description; Front Drive Shaft Construction - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (18 pages) ,
- Owner's manual (16 pages)
Table of Contents
3A-1 Drive Shaft / Axle: Front
Drive Shaft / Axle
Driveline / Axle
Front
Front Drive Shaft Construction
A constant velocity ball joint is used on the wheel side of both right and left side drive shaft assemblies. For A/T
vehicle, a tripod type constant velocity joint is used on the differential side and center shaft side. For M/T vehicle, a
double offset type constant velocity joint (DOJ) is used on the differential side and center shaft side. The drive shaft
can slide through the tripod joint or the double offset joint (DOJ) in the extension/contraction direction.
Front Drive Shaft Assembly Components Location
1. To transaxle
2. Drive shaft assembly
3. Tie-rod end
4. Tie-rod end nut
5. Ball stud bolt
6. Drive shaft nut
: After tightening nut to specified torque,
caulk nut securely.
General Description
Component Location
7. Wheel nut
8. Center shaft assembly (if equipped)
9. Center bearing support bolts (if equipped)
10. Washer
: 45 N⋅m (4.5 kgf-m, 32.5 lb-ft)
: 60 N⋅m (6.0 kgf-m, 43.5 lb-ft)
S7RW0A3111001
S7RW0A3113001
I6RW0D311001-01
: 200 N⋅m (20.0 kgf-m, 145.0 lb-ft)
: 85 N⋅m (8.5 kgf-m, 61.5 lb-ft)
: 55 N⋅m (5.5 kgf-m, 40.0 lb-ft)
: Do not reuse.
Chapters
Table of Contents
Troubleshooting
