Steering Angle Sensor Removal And Installation; Steering Angle Sensor Inspection; Esp® Off Switch Removal And Installation; Esp® Off Switch Inspection - Suzuki SX4 Service Manual

Hide thumbs Also See for SX4:
Table of Contents

Steering Angle Sensor Removal and Installation

Removal
1) Remove steering wheel and contact coil cable
assembly. Refer to "Steering Wheel Removal and
Installation" and "Contact Coil Cable Assembly
Removal and Installation".
2) Remove steering angle sensor (2) from contact coil
cable assembly (3) while opening fitting parts (1) of
contact coil cable assembly.
1
2
3
Installation
1) Install steering angle sensor (2) by fitting
engagement parts (1) of contact coil cable assembly
to claws of steering angle sensor as shown in figure.
1
2
2) Install contact coil cable assembly and steering
wheel. Refer to "Contact coil Cable Assembly
Removal and Installation" and "Steering Wheel
Removal and Installation".

Steering Angle Sensor Inspection

• Check sensor for dents, cracks or deformation.
• Check sensor connector (sensor side and harness
side) and sensor connector lock mechanism for
damage or crack.
• Check connector terminals for bend, corrosion or rust.
If it is found faulty, replace steering angle sensor (1).
S7RW0A4606019
ESP® OFF Switch Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove rear console box referring to "Console Box
Components in Section 9H".
3) Disconnect ESP® OFF switch coupler.
4) Remove ESP® OFF switch (1) from rear console
1
box (2).
I6JB01620003-01
Installation
Reverse removal procedure.
1
ESP® OFF Switch Inspection
I6JB01620004-01
Check for continuity between terminals at each switch
position.
If check result is not as specified, replace ESP® OFF
switch (1).
S7RW0A4606020
[A]: Free
Electronic Stability Program:
1
2
[A]
[B]
[B]: Push
4F-57
1
I6JB01460033-01
S7RW0A4606021
1
I6RS0B460042-02
S7RW0A4606022
2
3
4
5
3
4
5
I6RS0B460043-02
Table of Contents
loading

Table of Contents