Side-Air Bag (Inflator) Module Removal And Installation - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (18 pages)
Table of Contents
8B-101 Air Bag System:
Side-Air Bag (Inflator) Module Removal and
Installation
WARNING
!
• Never attempt to disassemble or repair the
side-air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System",
"Precautions on Handling and Storage of
Air Bag System Components" and
"Precautions on Disposal of Air Bag and
Seat Belt Pretensioner" before starting to
work and observe every precaution during
work. Neglecting them may result in
personal injury or undeployment of the air
bag when necessary.
2
1
3
1
1. Side-air bag (inflator) module
2. Seat back frame bracket
3. Side-air bag (inflator) module
connector
4. Seat back
5. Air bag harness in floor harness
S7RW0A8206009
4
5
6
7
(a)
8
2
I7RW01822144-01
6. Sleeve
7. Sleeve lock nut
8. Fastener
: 2.5 N⋅m (0.25 kgf-m, 2.0
lb-ft)
: Do not reuse.
Removal
1) Disable air bag system. Refer to "Disabling Air Bag
System".
2) Loosen seat back surface fastener (1) and roll up
backside of seat back surface.
2. Seat back
3) Remove sleeve lock nut (1) from side-air bag
(inflator) module (2).
2
4) Remove side-air bag (inflator) module from seat
back.
5) Disconnect side-air bag (inflator) module connector
(1) as shown in the figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
1
2
1
I7RW01822145-01
1
2
I7RW01822146-01
a)
2
b)
I4RS0A820068-01
Chapters
Table of Contents
Troubleshooting
