Suzuki SX4 Service Manual page 1114
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (18 pages) ,
- Owner's manual (278 pages)
Table of Contents
8B-21 Air Bag System:
"AIR BAG" Warning Light Does Not Come ON
Wiring Diagram
Refer to ""AIR BAG" Warning Light Comes ON Steady".
Troubleshooting
Step
1
Was "Air Bag Diagnostic System Check Flow" performed?
2
Combination meter power feed circuit check
1) Set parking brake.
2) Note combination meter when ignition switch is turned
ON.
Does the "BRAKE" indicator (warning light) come ON?
3
"AIR BAG" warning light circuit check
1) Disconnect SDM connector "L04".
2) Note combination meter when ignition switch is turned
ON.
Does the "AIR BAG" warning light come ON?
4
"AIR BAG" warning light circuit check
1) Disconnect SDM connector "L04".
2) With ignition switch turned ON, measure voltage
between "L04-02" terminal and body ground.
Special tool
(A): 09932–76010
"L04-2"
Is measured voltage 0 V?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
(A)
I7RW01822135-01
Yes
Go to Step 2.
Go to Step 3.
Substitute a known-
good SDM and recheck.
Replace combination
meter.
S7RW0A8204008
No
Go to "Air Bag
Diagnostic System
Check Flow".
Check combination
meter power and
ground circuit referring
to "C-1 Combination
Meter Circuit Diagram
(Meter) in Section 9A".
Go to Step 4.
Repair "YEL/BLK"
circuit for short to power
circuit.
Chapters
Table of Contents
Troubleshooting
