Dtc C1071: Control Module Internal Defect; Dtc C1075: Steering Angle Sensor Calibration - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (278 pages)
Table of Contents
4F-46 Electronic Stability Program:
DTC C1071: Control Module Internal Defect
DTC Detecting Condition and Trouble Area
DTC Detecting Condition
ESP® control module internal defect is detected.
DTC Troubleshooting
Step
1
Was "Electronic Stability Program Check" performed?
2
Check ESP® hydraulic unit / control module assembly
power and ground circuit
1) Check that ESP® hydraulic unit / control module
assembly power supply circuit and ground circuit is in
good condition referring to "ESP® Hydraulic Unit /
Control Module Assembly Power and Ground Circuit
Check".
Are check results OK?
DTC C1075: Steering Angle Sensor Calibration
DTC Detecting Condition and Trouble Area
DTC Detecting Condition
C1075:
Missing steering angle sensor calibration point data is
detected.
DTC Troubleshooting
Step
1
Was "Electronic Stability Program Check" performed?
2
DTC check for ESP®
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ignition switch ON and check DTC for ESP®.
Is there any DTC(s) other than C1075?
3
Check sensor calibration
1) Calibrate steering angle sensor referring to "Sensor
Calibration".
2) Clear all DTC(s) and check DTC for ESP®.
Is DTC C1075 still detected?
Action
Action
Trouble Area
• ESP® control module
Yes
Go to Step 2.
Substitute a known-
good ESP® hydraulic
unit / control module
assembly and recheck.
Trouble Area
• Steering angle sensor
• Steering angle sensor calibration is incompleted
• ESP® control module
Yes
Go to Step 2.
Go to applicable DTC
diag. flow.
Substitute a known-
good steering angle
sensor and recheck. If
DTC C1075 is still
detected, substitute a
known-good ESP®
hydraulic unit / control
module assembly and
recheck.
S7RW0A4604049
No
Go to "Electronic
Stability Program
Check".
Repair ESP® hydraulic
unit / control module
assembly power or
ground circuit.
S7RW0A4604032
No
Go to "Electronic
Stability Program
Check".
Go to Step 3.
Calibration was
incompleted.
Chapters
Table of Contents
Troubleshooting
