Suzuki SX4 Service Manual page 1128
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (18 pages)
Table of Contents
8B-35 Air Bag System:
DTC Troubleshooting
Step
1
Was "Air Bag Diagnostic System Check Flow" performed?
2
Driver air bag circuit check
1) With ignition switch turned OFF, disconnect contact coil
connector "G347" located under the steering column.
2) Disconnect SDM connector "L04".
3) Check for proper connection to flow harness connector
at terminal in "G347" connector.
4) Check for proper connection to SDM connector at
terminal "L04-3" and "L04-4".
5) If OK, release shorting bar in SDM connector inserting
release tool (1) included in special tool (A).
Special tool
(A): 09932–76010
6) Measure resistance between "G347-1" terminal and
body ground, and between "G347-2" terminal and body
ground.
"L04-3"
1,(A)
Is each measured resistance infinity?
3
Floor harness circuit check
1) Disconnect "L378" connector located near the driver side
front pillar lower trim.
2) If OK, release shorting bar in SDM connector inserting
release tool (1) included in special tool (A).
Special tool
(A): 09932–76010
3) Measure resistance between "L378-1" terminal and body
ground, and between "L378-2" terminal and body
ground.
"L04-3"
1,(A)
Is each measured resistance infinity?
Action
"L04-4"
(A)
"L04-4"
(A)
Yes
Go to Step 2.
Go to Step 4.
I7RW01821020-01
Repair "GRN/RED"
circuit or "GRN" circuit
for short to ground at
instrument panel
harness.
I7RW01821020-01
No
Go to "Air Bag
Diagnostic System
Check Flow".
Go to Step 3.
Repair "GRN/RED"
circuit or "GRN" circuit
for short to ground at
floor harness.
Chapters
Table of Contents
Troubleshooting
