Suzuki SX4 Service Manual page 460
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (278 pages) ,
- Owner's manual (16 pages)
Table of Contents
2C-9 Rear Suspension:
8) If necessary, remove wheel stud bolts (1) with
copper hammer or hydraulic press.
CAUTION
!
Never remove bolt unless replacement is
necessary.
Be sure to use a new bolt for replacement.
Installation
CAUTION
!
Rear hub bolt is pre-coated with friction
stabilizer.
Never reuse the removed bolt. Otherwise,
bolt may loosen.
1) Insert wheel stud bolt (1) in hub hole. Rotate wheel
stud bolt slowly to assure that serrations are aligned
with those made by original bolt.
1
2) Install brake back plate, rear wheel hub and new rear
3) Connect wheel speed sensor connector (1) (4WD
4) Install wheel speed sensor (2) and tighten wheel
1
I5JB0A220016-01
5) Connect brake pipe (1) to wheel cylinder and tighten
I5JB0A220017-01
hub bolts and then tighten rear hub bolts to specified
torque.
Tightening torque
Rear hub bolt (a): 73 N·m (7.3 kgf-m, 53.0 lb-ft)
model).
speed sensor bolt to specified torque (2WD model).
Tightening torque
Wheel speed sensor bolt (b): 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
[A]
(a)
[B]
[A]: 4WD model
[B]: 2WD model
brake pipe flare nut to specified torque.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5
lb-ft)
1
(a)
2
(b)
I8RW01230006-01
(a)
1
I5RW0A230018-01
Chapters
Table of Contents
Troubleshooting
