Scan Tool Data - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (18 pages) ,
- Owner's manual (278 pages)
Table of Contents
Scan Tool Data
Scan tool data
Accel pedal Pos
Engine speed
4WD mode
4WD current
Battery voltage
Coupling temp
Wheel speed (F)
Wheel speed (R)
F-R Wheel speed
Diff
4WD duty
Scan Tool Data Definitions
Accel pedal Pos (Accelerator pedal position) (%)
Accelerator pedal opening ratio detected by signal on
CAN communication line fed from ECM.
Engine Speed (RPM)
This parameter indicates engine revolution calculated by
4WD control module.
4WD mode (2WD / AUTO / LOCK / ABS mode / Yaw
cont / ESP® req)
This parameter indicates 4WD mode according to 2WD/
4WD switch signal status detected by 4WD control
module.
4WD current (A)
This parameter indicates input current of coupling
assembly.
Battery voltage (V)
This parameter indicates battery voltage detected by
4WD control module.
Vehicle condition
Ignition switch ON after
warmed up engine
At engine idle speed
2WD/4WD switch selected to 2WD position
2WD/4WD switch selected to AUTO position
2WD/4WD switch selected to LOCK position
ABS operating
Ignition switch ON and engine stop
Stability control operating
ESP® operating
Engine running
At engine idle speed
Engine running
Vehicle stop
Vehicle stop
Vehicle stop
Ignition switch ON and 2WD/4WD switch selected to
2WD position
Accelerator pedal released
Accelerator pedal depressed
fully
Coupling temp (°C, °F)
Coupling temperature detected by coupling air
temperature sensor installed in coupling assembly.
Wheel speed (F), Wheel speed (R) (km/h, mph)
Wheel speed is an ABS / ESP® control module internal
parameter. It is computed by reference pulses from the
wheel speed sensor.
F-R Wheel speed diff (Front-rear wheel speed
differential) (rpm)
This parameter indicates rotation difference between
front wheel and rear wheel detected by 4WD control
module.
4WD duty (%)
This parameter indicates operation rate of coupling
assembly.
Differential:
S7RW0A3204009
Normal condition / reference
values
0 – 5%
90 – 100%
Engine idle speed is display
2WD
AUTO
LOCK
ABS mode
Relay off
Yaw cont
ESP® mode
0 – 200 mA
10 – 14 V
–40 °C – 100 °C (–40 °F – 212 °F)
0 km/h, 0 MPH
0 km/h, 0 MPH
0 rpm
0%
3B-14
Chapters
Table of Contents
Troubleshooting
