Oil Pan And Oil Pump Strainer Removal And Installation - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (278 pages) ,
- Owner's manual (16 pages)
Table of Contents
Oil Pan and Oil Pump Strainer Removal and
Installation
Removal
1) Remove oil level gauge.
2) Drain engine oil by removing drain plug.
3) For 4WD model, dismount transfer referring to
"Transfer Dismounting and Remounting in Section
3C".
4) Remove clutch housing lower plate (1).
5) Remove oil pan and then oil pump strainer (1) from
cylinder block.
Installation
1) Install new O-rings (2) in the position as shown in the
figure and install oil pump strainer (1).
Tighten strainer bolt (3) first and then bracket bolt (4)
to specified torque.
Tightening torque
Oil pump strainer bolt (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
Oil pump strainer bracket bolt (b): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
S7RW0A1506002
2) Install dowel pin (1) to oil pan.
1
I5RW0A150002-01
3) Apply sealant continuously to oil pan mating surface
as shown in the figure.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Sealant amount for oil pan
Width "a": 3 mm (0.12 in.)
Height "b": 2 mm (0.08 in.)
I2RH0B150010-01
Engine Lubrication System:
1E-4
I2RH0B150012-01
I4RS0A150005-01
I4RS0A150006-01
Chapters
Table of Contents
Troubleshooting
