Table of Contents
15. Install the new springs into the grooves of the cam
gear.
16. Insert the pointed dowels from the Tapered Pins (PU-
45497-1) into the cam gear.
To Assemble:
• Hold the spring with one finger.
• Start the pointed end of the tapered pin into the
cam gear hole. Slowly push the dowel through the
hole until the end of the dowel is almost flush with
the spring.
• Perform this procedure with all three tapered pins.
• Do not push the pins too far through or the springs
will pop out.
NOTE: Do not remove the tapered pins at this
time.
17. Note in photograph that the Tapered Pins (PU-
18. Line up the two gears using the timing marks and the
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
45497-1) are below flush with end of the springs.
This helps to align the three gear tabs during the
next step.
Cam Gear Spring Installation Tool Kit:
(PU-45497)
Tapered Pins:
(PU-45497-1)
Cam Gear Tooth Align Tool:
(PU-45497-2)
three gear tabs referenced earlier. Push the gears
back together, using both hands and hold securely.
ENGINE
3
3.47
Chapters
Table of Contents
Troubleshooting
