Table of Contents
5. Remove the (5) screws retaining the park flange.
Inspect the park flange for wear or damage. Replace
if needed.
6. Inspect the shaft bearing. Use a standard bearing
puller to remove the shaft bearing if required.
NOTE:
Do not pull bearing from case for
inspection, as the removal process damages the
bearing.
7. Remove the reverse idler snap ring, upper washer,
8. Remove the input shaft seal and clutch intermediate
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
TRANSMISSION
gear, needle bearing, and lower washer from the
idler shaft.
NOTE:
The reverse idler shaft is a non-
serviceable item and should not be pressed out
of the housing.
shaft seal using a seal puller or punch.
8
8.15
Chapters
Table of Contents
Troubleshooting
