Table of Contents
ENGINE
34. Install a new gear/stator housing gasket onto the
crankcase.
35. With both seal savers installed, carefully place the
gear / stator housing cover over the protection tools
and onto the crankcase.
36. Secure the gear / stator housing cover to the
crankcase with the cover bolts. Torque bolts in
proper sequence to specification. Remove seal
protectors from the shaft ends once the cover is
secure.
Gear / Stator Housing Bolt:
96 ± 12 in-lbs (10.85 ± 1.35 Nm)
Torque in proper sequence
NOTE: Before assembly, clean the bolts and bolt
holes with Primer N (commercially available) to
remove any debris. This will ensure proper
sealing when installing bolts.
3.64
37. Install shaft seal with ceramic surface facing inward.
38. Install water pump impeller (P). Secure the impeller
with the washer and a new nut (Q). Torque the nut
to specification.
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
Water Pump Impeller Nut:
108 ± 6 in-lbs (6.8 ± 0.68 Nm)
Chapters
Table of Contents
Troubleshooting
