Table of Contents
FINAL DRIVE
7. Remove the input shaft seal using a seal puller or
other suitable method.
8. Inspect the input shaft by rotating the assembly in
the gearcase housing while checking for any
looseness or roughness. Inspect the pinion gear
teeth for chipped, worn, or broken teeth. If damaged,
replace the ring gear and pinion gear as a set.
NOTE: In the event damage to the gears, pinion
bearings or housing requires replacement, the
entire assembly must be replaced.
7.48
Gearcase Assembly
1. Install a new input shaft seal using a standard seal
installer or other suitable method.
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
Chapters
Table of Contents
Troubleshooting
