Table of Contents
BODY / STEERING / SUSPENSION
DECAL REPLACEMENT
WARNING
The following procedure involves the use of an open
flame. Perform this procedure in a well ventilated area,
away from gasoline or other flammable materials. Be
sure the area to be flame treated is clean and free of
gasoline or flammable residue.
WARNING
Do not flame treat components that are installed on the
vehicle. Remove the component from the vehicle
before flame treating.
The side panels, front and rear fender cabs are plastic
polyethylene material. Therefore, they must be "flame
treated" prior to installing a decal to ensure good
adhesion. A bonus of the flame treating procedure is it
can be used to reduce or eliminate the whitish stress
marks that are sometimes left after a fender or cab is
bent, flexed, or damaged.
CAUTION
Do not flame treat painted plastic components. Painted
plastic surfaces should only be wiped clean prior to
decal adhesion.
To flame treat the decal area:
1. Pass the flame of a propane torch back and forth
quickly over the area where the decal is to be applied
until the surface appears slightly glossy. This should
occur after just a few seconds of flame treating. Do
not hold the torch too close to the surface (2-3 inches
from the flame tip is recommended). Keep the torch
moving to prevent damage.
2. Apply the decal on one edge first. Slowly lay down
remainder of the decal while rubbing lightly over the
decal surface to eliminate any air bubbles during the
application.
5.48
SHOCKS / SPRINGS / FASTENERS
Exploded View (RZR / RZR S)
Exploded View (RZR S / RZR S INT'L)
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
Chapters
Table of Contents
Troubleshooting
