Table of Contents
ELECTRICAL
2. Test between the 2 sets of outputs (AWD / 2WD). If
any of the tests fail, replace the switch assembly.
• Move the switch to AWD (ON). There should be
continuity between switch pins 2 and 3 as well as 3
and 7.
• Move the switch to 2WD (NONE / OFF). There should
ONLY be continuity between pins 3 and 7.
SEAT BELT SWITCH
Location
Found on the driver's seat belt latch
Functionality
If the circuit is open (buckle undone) vehicle speed will
be limited to 15mph. If the circuit is closed (buckle
inserted), the vehicle will function normally.
Testing:
1. Disconnect the harness
11.26
q
running to the seat belt.
2. Using a multi-meter, measure between both pins on
switch.
SEAT BELT
DISENGAGED
Between both
pins on switch
TRANSMISSION / GEAR POSITION SWITCH
TESTING
1. The transmission (gear position) switch
on the RH side of the transmission and can be
accessed through the rear RH wheel well area.
2. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
3. Test the transmission switch continuity readings for
each gear position and compare to the specification
table below.
GEAR
WHEN MEASURED AT SWITCH
POSITION
HIGH
LOW
NEU
REV
PARK
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
SEAT BELT
ENGAGED
∞ (OL)
< 1 Ω
q
is located
RESISTANCE VALUE
TERMINALS A AND B
620 Ω
300 Ω
160 Ω
75 Ω
24 Ω
© Copyright Polaris Industries Inc.
Chapters
Table of Contents
Troubleshooting
