Table of Contents
ENGINE / COOLING SYSTEM
ENGINE ASSEMBLY - TOP END
CYLINDER HEAD ASSEMBLY
Assemble the valves one at a time to maintain proper
WARNING
Wear eye protection during cylinder head disassembly
and reassembly or when working with the valve springs.
1. Apply engine oil to valve guides and seats.
2. Coat valve stem with Premium Starter Grease
(2871460).
q
3. Install the valve
in the cylinder head, through the
guide.
4. Carefully install a new valve seal / seat
valve guide with a rotating motion. Push firmly until
seated in retaining groove and square with the guide.
Valve seals should be installed AFTER the valves are in
the head to avoid valve seal damage.
5. Dip the valve spring
engine oil.
3.84
NOTE
order.
w
NOTE
e
r
and retainer
in clean
6. Install the valve spring with widely spaced coils
the top and tightly spaced coils
the cylinder head.
Valve springs to be installed with paint mark facing up.
7. Place the valve retainer on the spring.
8. Compress the valve spring by hand using valve
spring compressor adapter (PV-43513-A). Compress
spring only enough to allow split keeper installation.
on the
To prevent damage to the valve seals, do not compress
the valve spring more than necessary to install the
9. Install split keepers
10. Repeat this procedure for remaining valves.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
u
facing down toward
NOTE
NOTE
keepers.
t
with gap even on both sides.
© Copyright Polaris Industries Inc.
y
on
Chapters
Table of Contents
Troubleshooting
