Table of Contents
REAR BEARING CARRIER INSTALLATION
1. Install drive shaft through the backside of the bearing
carrier.
2. Install the four fasteners
bearing carrier to the trailing arm. Install the one
w
fastener
that attaches the upper radius rod to the
bearing carrier. Torque bolts to specification.
NOTE
Use new nuts upon installation of the rear bearing
carrier.
TORQUE
Bearing Carrier to Trailing Arm Bolts:
42 ft-lb (54 Nm)
Radius Rod to Bearing Carrier Fasteners:
50 ft-lb (68 Nm) + 45°
3. Apply anti-seize to drive shaft splines.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
4. Install rear wheel hub assembly
5. Install the rear brake caliper assembly and new bolts
q
that attach the rear
and hand tighten the castle nut. Install washers with
domed side out.
r
. Torque to specification.
TORQUE
Rear Caliper Mounting Bolts:
46 ft-lbs (62 Nm)
FINAL DRIVE
w
e
, cone washers
,
7
7.9
Chapters
Table of Contents
Troubleshooting
