Table of Contents
3. Lubricate the mounting bracket pins
grease and install the rubber dust seal boots
4. Compress the mounting bracket and make sure the
dust seals are fully seated. Install the brake pads.
Clean the disc and pads with brake parts cleaner or
denatured alcohol to remove any dirt, oil or grease.
REAR BRAKE DISC INSPECTION
1. Visually inspect disc for scoring, scratches, or
gouges. Replace disc if deep scratches are evident.
2. Use a 0-1" micrometer and measure disc thickness at
eight different points around the pad contact surface.
Replace disc if worn beyond service limit.
Brake Disc Thickness
.295 ± .008"(7.5 ± .2 mm)
.268" (6.8 mm)
Brake Disc Thickness Variance:
Service Limit: 0.002" (0.051 mm)
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
r
with silicone
3. Mount a dial indicator and measure disc runout.
t
.
Slowly rotate the disc and read total runout on the dial
indicator. Replace the disc if runout exceeds
specifications.
REAR BRAKE DISC REPLACEMENT
1. Remove rear brake caliper (see Brake Caliper / Pad
Removal, page 9.24).
2. Remove wheel hub cotter pin
washers
3. Remove the hub assembly from the vehicle and
remove the four studs
4. Clean the wheel hub mating surface and install new
disc on wheel hub.
5. Install new studs
6. Install wheel hub assembly, washers, and castle nut.
Torque castle nut to specification and install a new
cotter pin.
BRAKE SYSTEM
Brake Disc Runout:
.010" (0.25 mm)
r
, castle nut
w
.
q
retaining the disc to the hub.
t
.
TORQUE
Rear Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)
e
and
9
9.27
Chapters
Table of Contents
Troubleshooting
