Table of Contents
ELECTRICAL
INSTRUMENT CLUSTER PINOUTS
FUNCTION
CAN High
CAN Low
Constant Power (Vdc)
Switched Power (Vdc)
Ground
Fuel Level Sensor
INSTRUMENT CLUSTER REMOVAL
Do not allow alcohol or petroleum products to come in
contact with the instrument cluster lens.
1. Remove the hood.
2. Remove the two T-40 Torx screws
front part of the upper hood panel. Carefully lift the
panel to access the instrument cluster wiring.
3. Disconnect the wire harness connector
back side of the instrument cluster.
11.24
PIN
1
2
3
4
5
11
NOTE
q
retaining the
w
from the
4. Push the instrument cluster out from the back side of
the dash while securely holding the dash and rubber
mount.
Do not remove the rubber mount from the dash panel.
Only remove the rubber mount if necessary. The bezel
is a snap-on assembly and is a serviceable part.
INSTRUMENT CLUSTER INSTALLATION
1. Spray a soap and water mixture onto the outer
surface area of the instrument cluster. This will help
the instrument cluster slide into the rubber mount
more easily.
2. Be sure the rubber mount inside the dash is fully
installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash.
3. Hold the dash securely and insert the instrument
cluster into the dash. Apply pressure on the bezel
while pressing down on the instrument cluster.
4. Reconnect the wiring harness to the instrument
cluster.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
NOTE
© Copyright Polaris Industries Inc.
Chapters
Table of Contents
Troubleshooting
