Table of Contents
BRAKE SYSTEM
7. Install rear caliper (see Brake Caliper / Pad
Installation, page
). Bleed the brake system. (See
BRAKE BLEEDING / FLUID CHANGE, page 9.11.
8. Field test unit for proper braking action before putting
into service. Inspect for fluid leaks and firm brakes.
Make sure brakes do not drag when pedal is
released. If the brakes drag, re-check assembly and
installation.
REAR BRAKE CALIPER / PAD
INSTALLATION
1. Install the rear caliper with new mounting bolts.
Torque mounting bolts
TORQUE
Rear Caliper Mount Bolt
46 ft-lbs (62 Nm)
9.28
q
to specification.
q
:
2. Install brake line banjo bolt
fitting to the caliper. Properly orient the brake line
fitting to the caliper as shown. Torque banjo bolt to
specification.
The vertical centerline used for measurement is based
on the caliper pin locations.
Banjo Bolts:
15 ft-lb (20 Nm)
3. Install lower radius rod bolt, washer and new nut.
Torque to specification.
TORQUE
Radius Rod to Bearing Carrier Bolt:
50 ft-lb (68 Nm) + 45°
4. Install the pad adjustment screw and turn until
stationary pad contacts disc, then back off 1/2 turn.
5. Follow bleeding procedure outlined earlier in this
chapter.
6. Install wheel and torque wheel nuts to specification.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
w
retaining the brake line
NOTE
NOTE
© Copyright Polaris Industries Inc.
Chapters
Table of Contents
Troubleshooting
