Table of Contents
DEMONSTRATION MODE
When the vehicle is first keyed on, and the shift lever is in
the Park (P) position with the engine not running, the
SCM will enter a demonstration mode. The suspension
will react to the operator inputs as if the vehicle was
being driven. After a period of time (5 minutes), the SCM
will exit demonstration mode and stop driving the shocks
to conserve vehicle power. The vehicle will enter normal
operation if the engine is started.
NOTE
The vehicle will enter demonstration mode any time the
shift lever is in the park position (P), the engine speed is
at 0 rpm, and the vehicle speed is at 0 mph.
Demonstration mode will time out after 5 minutes.
SUSPENSION CONTROL MODULE (SCM)
The Suspension Control Module (SCM) contains the
logic for suspension control, including communications,
operator inputs, and shock drivers, to execute the
suspension control algorithms. The SCM also has an
internal 6-axis inertial measurement unit which is used to
monitor the performance of the vehicle by the
suspension control algorithms.
CAUTION
Moving or altering the orientation of the SCM may have
an adverse effect on vehicle handling. Never move the
SCM from it's factory mounting location.
SCM REPLACEMENT
1. Remove the hood.
2. Remove the two fasteners
panel cover. The cover does not need to be removed,
just moved to access underneath it.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
q
retaining the instrument
STEERING / SUSPENSION
3. Remove the four fasteners
mounting plate to the frame.
4. Unlock the connector from the SCM by sliding the tab
outward, as shown, then pull the connector off the
SCM.
e
5. Remove the 4 fasteners
mounting plate.
6. The SCM MUST be mounted with FRONT label
properly facing the front of the vehicle when installed.
Failure to do this will have an adverse effect on
vehicle handling.
7. Install the SCM on the mounting plate. Torque
mounting fasteners to specification.
TORQUE
SCM Mounting Fasteners:
8 ft-lb (11 Nm)
8. Install the harness onto the SCM. Slide the tab inward
to lock the harness to the SCM. Lightly pull on the
connector to ensure it is retained.
9. Install the SCM / mounting plate assembly into the
vehicle. Torque mounting fasteners to specification.
IMPORTANT
A sticker with an arrow on the SCM indicates which side
MUST face the front of the vehicle.
w
retaining the SCM
8
retaining the SCM to the
8.53
Chapters
Table of Contents
Troubleshooting
