Table of Contents
6. Using an appropriate bearing/bushing installation
sleeve, drive the support bearing assembly onto the
prop shaft until it seats against the shoulder on the
shaft.
NOTE
Only drive on the inner race of the bearing. Driving on
the bearing in any other location will damage the
bearing.
7. Wipe the bearing and shaft clean of any excess
retaining compound.
NOTE
Do not allow any Loctite
®
8. Install the rear prop shaft into the vehicle (see
Chapter 7 – Rear Prop Shaft Installation, page
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
to get in the bearing.
).
U-JOINT DISASSEMBLY
CAUTION
Always wear eye protection.
1. Remove internal snap ring
caps.
NOTE
If yoke or bearing is removed, cross bearing must be
replaced. Note orientation of grease fitting (if equipped)
and mark inner and outer yoke for correct re-positioning
during installation.
2. Support inner yoke as shown and drive outer yoke
down (bearing cap out) with a suitable press.
FINAL DRIVE
q
from all four bearing
7
7.25
Chapters
Table of Contents
Troubleshooting
