Table of Contents
SHIFT LEVER / CABLE
SHIFT LEVER REMOVAL
1. Remove the shift knob cover
e
and shift knob
from the shift lever
2. Remove the fasteners retaining the center console
(see Body / Frame chapter). Remove the console
from the vehicle.
3. Remove the clip and washer retaining the shift cable
to the shift lever and disconnect the cable end from
the lever.
4. Remove the retaining ring
y
off the mounting bracket and out from the frame.
u
5. Remove both bushings
service as needed.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
q
w
, retaining screw
r
.
t
and slide the shift lever
from the shift lever and
SHIFT LEVER INSTALLATION
Perform the removal steps in reverse order to install the
gear shift lever (lever, cable, console, shift knob).
SHIFT CABLE INSPECTION
Shift cable adjustment may be necessary if symptoms
include:
• No gear position or AWD display on instrument cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear lash (noise)
• Gear selector moving out of desired range
Inspect shift cable, clevis pins, and pivot bushings and
replace if worn or damaged.
SHIFT CABLE ADJUSTMENT
1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.
q
2. Inspect shift cable
, clevis pin, pivot bushings, and
w
dust boot
. Replace if worn or damaged.
3. If adjustment is required, loosen the lower jam nut
and pull the cable out of the mount
t
upper jam nut
.
TRANSMISSION
6
r
e
to move the
6.3
Chapters
Table of Contents
Troubleshooting
