Table of Contents
•
When a normal HDD is mounted
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
Remarks:
If the HDD type cannot be identified, "Unknown HDD" may appear on the screen.
Refer to P. 8-195" [F106_1] ADI-HDD error: HDD type detection error"
Note:
When "SATA HDD" (normal HDD) is displayed, items 1 and 2 are not selectable.
If you select any of 1 and 2 and press the [START] button, the error message below appears.
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
=>
2. Remove key
Operation Failed.
Press SoftPower Key to Switch Off
5.10.3
Functions
[A] 1. Revert factory initial status HDD
Select this to dispose of the HDD as well as the equipment.
When this item is selected, all data in the HDD are deleted and the HDD is reverted to its initial status at
the factory shipment.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
System Firmware Version
Update Mode
Fig.5-8
System Firmware Version
Update Mode
Fig.5-9
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
5 - 23
: xxxx(x.x.x.x)
: 4c Mode
: xxxx(x.x.x.x)
: 4c Mode
SELF-DIAGNOSTIC MODE
5
- Quick Links:
- Service Manual
Hide quick links:
Table of Contents
Troubleshooting
