Table of Contents
(9)
Remove 2 screws each and take off the
pressure roller center thermostat and the
pressure roller side thermostat from each
bracket.
Notes:
•
Do not touch the temperature detection
section of the pressure roller thermostat.
•
When replacing the pressure roller center
thermostat or the pressure roller side one,
check the gap between this and the
pressure roller. P. 6-103"6.11.3 Gap
adjustment for pressure roller
thermostats"
•
Install the correct pressure roller
thermostat since the center and side ones
are similar but different.
4.9.16
IH coil
(1)
Take off the fuser unit.
P. 4-172"4.9.1 Fuser unit"
(2)
Open the SYS board case.
P. 9-2"9.1.3 SYS board case"
(3)
Release a harness from the clamp and
disconnect 2 connectors.
(4)
Remove 4 screws and take off the IH board
cover.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Pressure roller
side thermostat
Fig. 4-570
Pressure roller
side thermostat
Fig. 4-571
Fig. 4-572
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
4 - 197
Pressure roller
center thermostat
Pressure roller
center thermostat
IH board cover
DISASSEMBLY and REPLACEMENT
4
- Quick Links:
- Service Manual
Hide quick links:
Table of Contents
Troubleshooting
