Table of Contents
Notes:
1. Never turn the 2 couplings behind the
developer unit in a direction opposite to
the one shown with the arrow.
2. Be sure not to lose the scraper in the
developer. Make sure that the scraper is
installed passing through the hole, and
check if the coupling can be turned in the
direction of the arrow in the figure.
3. Be sure that there is no developer
material adhering to the driving gear in
the developer unit.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-331
Hole
Fig. 4-332
Fig. 4-333
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
4 - 113
Coupling
(for Developer sleeve)
Coupling (for Mixer)
Scraper
Developer drive gear
DISASSEMBLY and REPLACEMENT
4
- Quick Links:
- Service Manual
Hide quick links:
Table of Contents
Troubleshooting
